Departamento de Ciencia de Materiales
 

Departamento de Ciencia de Materiales

Universidad Politécnica de Madrid
E.T.S.I. de Caminos, Canales y Puertos

 

Inicio Docencia Investigación Directorio Instalaciones Seminarios Empleo Memoria


 

Francisco Gálvez Díaz-Rubio

Profesor Titular de Universidad
Departamento de Ciencia de Materiales
Universidad Politécnica de Madrid
E. T. S. de Ingenieros de Caminos Canales y Puertos
C/ Profesor Aranguren s/n
28040 Madrid, Espańa
Tel: (91) 336 66 83
Fax: (91) 336 66 80
fgalvez@mater.upm.es

 
 
 

Actividad docente

Grado en Ingeniería de Materiales
Máster en Ingeniería de Materiales
Máster y Doctorado en Ingeniería de las Estructuras, Cimentaciones y Materiales
  • Propiedades Dinámicas de Materiales

Actividad Investigadora

Publicaciones en revistas internacionales
  • B.Erice, M.J.Pérez-Martín, F.Gálvez. An experimental and numerical study of ductile failure under quasi-static and impact loadings of Inconel 718 nickel-base superalloy. International Journal of Impact Engineering 69 (2014) 11-24
  • B.Erice, F.Gálvez. A coupled elastoplastic-damage constitutive model with Lode angle dependent failure criterion. International Journal of Solids and Structures 51 (2014) 93-110
  • M.J.Pérez-Martín, A.Enfedaque, W.Dickson, F. Galvez. Impact Behavior of Hybrid Glass/Carbon Epoxy Composites. Journal of Applied Mechanics 80 (2013) 031803-1 031803-7
  • Antoine Jerusalem, William Dickson, Maria Jesús Pérez-Martín, Ming Dao, Jian Lu and Francisco Gálvez. Grain size gradient length scale in ballistic properties optimization of functionally graded nanocrystalline steel plates. Scripta Materialia 69 (2013) 773-776
  • N.V. Dudamell, P.Hidalgo-Manrique, A.Chakkedath, Z.Chen, C.J.Boehlert, F.Gálvez, S.Yi, J.Bohlen, D.Letzig, M.T.Pérez-Prado. Influence of strain rate on the twin and slip activity of a magnesium alloy containing neodymium. Materials Science and Engineering A 583 (2013) 220-231
  • David A. Cendón, Borja Erice, Francisco Gálvez and Vicente Sánchez-Gálvez. Numerical Simulation of Tangling in Jet Engine Turbines. International Journal of Turbo and Jet Engine 29 (2012) 269-282
  • M.J. Pérez-Martín, B. Erice, D.A. Cendón and F. Gálvez. Spalling uniaxial strength of Al2O3 at high strain rates. Eur. Phys. J. Special Topics 206 (2012) 117-128
  • B. Erice, M.J. Pérez-Martín, D.A. Cendón and F. Gálvez. Effect of the temperature, strain rate and microstructure on flow and fracture characteristics of Ti-45Al-2Nb-2Mn+0.8vol.% TiB2 XD alloy. Eur. Phys. J. Special Topics 206 (2012) 3-14
  • J. Frontán, Y. Zhang, M. Dao, J. Lu, F. Gálvez, A. Jérusalem. Ballistic performance of nanocrystalline and nanotwinned ultrafine cristal Steel. Acta Materialia 60 (2012) 1353-1367
  • N. V. Dudamell, I. Ulacia, F. Gálvez, S. Yi, J. Bohlen, D. Letzig, I. Hurtado, M.T. Pérez-Prado. Influence of texture on the recrystallization mechanisms in an AZ31 Mg sheet alloy at dynamic rates. Materials Science and Engineering A 532 (2012) 528-535
  • B. Erice, F. Gálvez, D. A. Cendón, V. Sánchez-Gálvez, Flow and fracture behaviour of FV535 steel at different triaxialities, strain rates and temperatures. Engineering Fracture Mechanics 79 (2012) 1-17
  • F. Gálvez J. M. Atienza, M. Elices. Behaviour of steel prestressing wires under extreme conditions of strain rate and temperature. Structural Concrete 12 (2011) 255-261
  • A. Enfedaque, D. Cendón, F. Gálvez, V. Sánchez-Gálvez. Failure and impact behavior of facade panels made of glass fiber reinforced cement (GRC). Engineering Failure Analysis 18 (2011) 1652-1663
  • N.V. Dudamell, I. Ulacia, F. Galvez, S. Yi, J. Bohlen, D. Letzig, I. Hurtado, M.T. Perez-Prado. Twinning and grain subdivision during dynamic deformation of a Mg AZ31 sheet alloy at room temperature. Acta Materialia 59 (2011) 6949-6962
  • B. Erice, F. Gálvez, D. A. Cendón, V. Sánchez-Gálvez, and T. Břrvik. An Experimental and Numerical Study of Ballistic Impacts on a Turbine Casing Material at Varying Temperatures. J. Appl. Mech. 78 (2011) 051019-1-12
  • G. Morales-Alonso, D. A. Cendón, F. Gálvez, B. Erice, and V. Sánchez-Gálvez. Blast Response Analysis of Reinforced Concrete Slabs: Experimental Procedure and Numerical Simulation. J. Appl. Mech. 78 (2011) 051010-1-12
  • A. Enfedaque, J.M. Molina-Aldareguía, F. Gálvez, C. González and J. LLorca. Effect of Glass Fiber Hybridization on the Behavior Under Impact of Woven Carbon Fiber/Epoxy Laminates. Journal of Composite Materials 44/25 (2010) 3051-3068
  • A.P. Zhilyaev, F. Gálvez, A. Sharafutdinov, and M.T. Pérez-Prado. Influence of the high pressure torsion die geometry on the allotropic phase transformations in pure Zr. Materials Science and Engineering A 527 (2010) 3918-3928
  • I.Ulacia, N. V. Dudamell, F. Gálvez, S. Yi, M.T. Pérez-Prado, I. Hurtado. Mechanical behavior and microstructural evolution of a Mg AZ31 sheet at dynamic strain rates. Acta Materialia 58 (2010) 2988-2998
  • A. Enfedaque, D.A. Cendón, F. Gálvez, V. Sánchez-Gálvez. Analysis of glass fiber reinforced cement (GRC) fracture surface. Construction and Building Materials 24 (2010) 1302-1308
  • F. Gálvez, D.A. Cendón, N. García, A. Enfedaque and V. Sánchez-Gálvez. Dynamic Fracture Toughness of a High Strength Armour Steel. Engineering Failure Analysis 16 (2009) 2618-2634
  • S. Chocron, A. Pintor, F. Galvez, C. Rossello, D. Cendon, V. Sanchez-Galvez. Lightweight polyethylene non-woven felts for ballistic impact applications: Material characterization. Composites Part B-Engineering 39 (2008) 1240-1246
  • F. Gálvez, D. Cendón, A. Enfedaque, V. Sánchez-Gálvez. High strain rate and high temperature behaviour of metallic materials for jet engine turbine containment. Journal de Physique IV France 134 (2006) 269-274
  • F. Gálvez, D. Cendón, V. Sánchez-Gálvez. Fracture strength of welded aluminium joints in commercial road vehicles. Engineering Failure Analysis 13 (2006) 260-270
  • F. Gálvez and V. Sánchez-Gálvez. Numerical modeling of SHPB splitting tests. Journal de Physique IV France 110 (2003) 347-352
  • S. He, P. Van Houtte, A. Van Bael, F. Mei, A. Sarban, P. Boesman, F. Galvez and J. M. Atienza. Strain rate effect in high-speed wire drawing process. Modelling Simul. Mater. Sci. Eng. 10 (2002) 267-276
  • F. Gálvez , J. Rodríguez, V. Sánchez-Gálvez. The spalling of long bars as a reliable method of measuring the dynamic tensile strength of ceramics. Int. J. of Impact Engineering 27 (2002) 161-177
  • F. Gálvez, C. González, P. Poza and J. Llorca. The effect of strain rate on the tensile deformation of Ti-6Al-4V / SiC composites. Scripta Materialia 44 (2001) 2667-2671
  • F. Gálvez, J. Rodríguez, V. Sánchez-Gálvez. Influence of the strain rate on the tensile strength in aluminas of different purity. Journal de Physique IV, France 10 (2000) 323-328
  • F. Gálvez, J. Rodríguez, V. Sánchez-Gálvez. A wave propagation technique to measure the dynamic tensile strength of brittle materials. Journal de Physique IV, France 10 (2000) 203-208
  • F. Gálvez, J. Rodríguez, V. Sánchez-Gálvez. Tensile strength measurements of ceramic materials at high rates of strain. Journal de Physique IV France 07 (1997) 151-156.